Vaddio WallVIEW PRO Z700 - Manual (Page 2)

WallVIEW PRO Z700 Installation and User Guide 341-674 Rev. B Page 2 of 12
UNPACKING
Carefully remove all of the parts from the packaging. Unpack and identify the following parts:
• One (1) - Sony BRC-Z700 High Definition PTZ Camera
• One (1) - Vaddio EZ Interface Module (EZIM)
• One (1) - Vaddio EZIM to HD camera break out cable
• One (1) - Vaddio Quick-Connect PRO with HSDS (1-RU Rack Mountable)
• One (1) - Vaddio Thin Profile Z700 Wall Mount
• One (1) - IR Remote Controller
• One (1) - EZCamera Control Adapter (RJ-45 to DB-9)
• One (1) - 36V PowerRite™ HD Power Supply with AC Cord Set
• One (1) - 2-position Phoenix Connector for IR
• Mounting Hardware
• Documentation
ƒ Vaddio Manual
ƒ Sony BRC-Z700 Manual
Optional Accessory:
Quick-Connect Boxes (2) for SD video (300 ft. limit) Part # - 998-1105-001
INSTALLATION
All WallVIEW products are specifically designed for installation on a vertical wall surface with Cat. 5 cable
connectivity for Power, Video and Control signaling (three cables are required). Installation is simplified in
that no custom 8-Pin mini-din cables or expensive S-Video plenum cables are needed and no power outlets
are required near the camera bracket. All cabling is routed to the head-end using Cat. 5 cables.
Before Installing
• Locate the camera mounting location paying close attention to camera viewing angles, lighting conditions,
possible line of site obstructions, and checking for in-wall obstructions where the camera is to be
mounted. Pick a mounting location to optimize the performance of the camera.
• Pre-wire all cabling as required (see wiring diagram examples).
• The Thin Profile Wall Mount for the WallVIEW HD1 can be mounted directly to a 3-gang wall box or can
be mounted to the drywall using four dry wall anchors.
Wiring Diagram Example
The Basic Idea:
Figure 2: Basic connectivity of the WallVIEW PRO HD-700 System.
The WallVIEW PRO HD-700 uses a Cat. 5 (all 4-pairs) for power to ensure the direct drive motors receive the
required current to operate properly. The Video Cat. 5 uses 3-pairs of the Cat. 5 for Video and 1-pair for IR
forwarding. The RS-232 Cat. 5 uses 5 conductors for RS-232 with provision for daisy chain controllers. These Cat.
5 cables can be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out information
Component Video (Y, Pb, Pr)
to HD video device
36 VDC PowerRite
Power Supply
IR Output
(see p. 4)
WallVIEW Z700 with Camera, Wall
Mount and EZIM (inside Wall Mount)
Quick-Connect Pro
Rack Mount Interface
Up to 500’ (152.4m) of Cat. 5
for Power, Video and Control
Power Cat. 5
Video Cat. 5
RS-232 Cat. 5
HD Video Device/Switcher