Vaddio WallVIEW PRO Z700 - Manual (Page 3)

WallVIEW PRO Z700 Installation and User Guide 341-674 Rev. B Page 3 of 12
Daisy Chain Control Configuration:
The WallVIEW PRO HD-700 has provisions for daisy chaining control signals when using a RS-232
controller with only one (1) RS-232 output. Each WallVIEW PRO EZIM has a RS-232 input and a RS-232
output (see Figure 3).
MOUNTING INSTRUCTIONS
Step 1:
After determining the optimum location of the camera system, route the required 3 (three) Cat. 5 cables from
the camera to the Quick-Connect Pro interface located at the head-end. The three Cat. 5 cables should
feed-through the oval slot located on the rear flange of the wall mount (Figure 4). If the bracket is to be
mounted on a 3-gang wall box, use the screws supplied with the wall box cover plate to attach the Thin
Profile Wall Mount. If mounting to the drywall with wall anchors, use four (4) quality wall anchors. The
mounting holes are slotted and are 90° opposing to provide easy leveling. Level the mount and tighten down
the mounting screws.
Step 3:
Connect the 25-pin end of the break out cable to the EZIM. Next, mount
the EZIM to the back of the wall mount on the left side, using the two
tapped screw holes (see Figure 6). Connect the 15-pin video cable,
power connector and 8-pin mini-DIN connectors (VISCA IN is labeled)
from the EZIM to the back of the camera.
Figure 3:
Daisy chain control configuration using two (2) WallVIEW PRO HD1 systems and a single RS-232
output control device. See Appendix 1 for wiring and pin-out information.
RS-232 Out
RS-232 Out RS-232 Input RS-232 Input
Figure 4:
Thin Profile Wall Mount with oval cable
feed-through hole. The wall mount may be
mounted directly to a 3-gang wall box or to
the dry wall with the appropriate wall
anchors.
Figure 5:
25-pin break out cable
connected to EZIM
(left); EZIM and break
out cable installed in
Wall Mount (right).