Wittco 580 - Manual (Page 6)

H & T CABINETS F-41013 (02-13)
5
All cabinets are
equipped with a three-prong plug. It
is imperative that this plug must be
connected into a properly grounded
three-prong receptacle. If the
receptacle is not the proper
grounding type, contact an
electrician. Do not remove the
grounding prong from this plug.
Verify that the power source
matches the Serial Data Plate located
on the lower back corner of the
cabinet and the plug configuration
before connection is made.
(Fig.2)
OPERATION
CONTROLS
The Cabinet and its parts
are hot. Be very careful when operating,
cleaning, or servicing the cabinet.
POWER FULL-RANGE FAN ON/OFF
INDICATOR THERMOSTAT SWITCH **
LIGHT
THERMOMETER HEAT INDICATOR LIGHT
(Fig. 3)
Power Indicator Light:
The Red Power Indicator Light indicates
power is supplied to the cabinet. The
red light will stay lit as long as the
cabinet is plugged in.
Heat Indicator Light:
The Amber Heat Indicator Light
indicates the heating element(s) are
heating. The amber light will stay lit as
long as the heating element(s) are
engaged. Once the predetermined
temperature is achieved, the heating
element(s) will begin to cycle. During
this period, the amber light will turn on
and off.
Fan On/Off Switch:
** Models manufactured after 2010
The Fan On/Off Switch turns the fan on
only. The use of the fan is optional.
Turn on fan if forced air holding is
desired.
Thermometer:
The Thermometer indicates the interior
temperature of the cabinet.
Thermostat:
The Thermostat turns power on to the
heating element(s). The thermostat
setting is from 1 to 10. The greater the
thermostat setting number, the higher
the temperature. (Fig. 4)