American Electric Lighting 325 fg new - Manual

325 SERIES HORIZONTAL LUMINAIRE
INSTALLATION INSTRUCTIONS
American Electric Lighting a division of Acuity Lighting Group, Inc. Conyers, GA
DRAWING NO. B62853 REV E ©2003 ACUITY LIGHTING GROUP, INC. PART NUMBER 057-71-62853
3
4
2
A
B
C
D
TYPE IIIMC
TYPE IIMC
TERMINAL BLOCK. VERIFY THAT SUPPLY VOLTAGE IS CORRECT
AS NOTED ON THE TERMINAL BLOCK LABEL. REFER TO THE WIRING
INFORMATION AND RATINGS.
DIAGRAM AND THE DATA ON THE BALLAST FOR CONNECTION
CLEAN OR REPLACE AS DESIRED.
SUPPORT THE REFRACTOR AT ALL TIMES. REMOVE REFRACTOR
HOUSING". ROTATE THE REFRACTOR LATCH BEING CAREFUL TO
OPEN THE LOWER DOOR AS OUTLINED UNDER "REMOVE LOWER
REFRACTOR REPLACEMENT
DETERGENT AND RINSED WITH CLEAN WATER TO MAINTAIN EFFICIENCY.
THE OPTICAL ASSEMBLY SHOULD BE CLEANED WITH A MILD
MAINTANCE AND CLEANING
AND TIGHTEN SCREW.
LOOSEN THE SCREW (DO NOT REMOVE) SLIDE TO NEW POSITION
SOCKET ADJUSTMENT
AND CONNECT THEM TO THE PROPER TERMINALS ON THE
THEM SO THEY DO NOT INTERFERE WITH ANY COMPONENTS,
FEED THE SUPPLY WIRES THROUGH THE MAST ARM, DRESS
WIRING
BOLTS TO 10 ft. lbs.
THE FRONT ONES. WHEN THE LUMINAIRE IS LEVEL, TORQUE
HIGH, LOOSEN THE TWO REAR FITTER BOLTS AND TIGHTEN
UNTIL THE LUMINAIRE IS LEVEL. IF THE FRONT END IS
TIGHTEN THE TWO REAR ONES. REPEAT THIS PROCEDURE
IS LOW, LOOSEN THE TWO FRONT FITTER BOLTS AND
MAST ARM UNTIL IT IS LEVEL. IF THE FRONT END
FROM SIDE TO SIDE, TWIST THE LUMINAIRE ON THE
THE LUMINAIRE. IF THE LUMINAIRE IS NOT LEVEL
PLACE A LEVEL ON THE AREA PROVIDED ON TOP OF
LEVELING
BOLTS FINGER TIGHT.
LUMINAIRE ON TO MAST ARM TO STOP AND TIGHTEN
MOUNTING LUMINAIRE ON A 2" MAST ARM. SLIDE
REMOVE CENTER OF BIRD SHIELD IF YOU ARE
1 1/4" MAST ARM & 1 1/4" FOR 2" MAST ARM.
LOOSEN FITTER CLAMP BOLTS. ABOUT 1/2" FOR
MOUNTING/LEVELING
LIFT OFF UPPER HOUSING.
LATCH. ROTATE LOWER HOUSING ABOUT 140° AND
OPEN LOWER HOUSING BY PULLING ON FRONT TRIGGER
REMOVE LOWER HOUSING
UPPER HOUSING
TRIGGER LATCH
BEZEL DOOR
REFRACTOR
1/4" SCREW
BALLAST DOOR LATCH
BALLAST DOOR
LIGHT DISTRIBUTION
200-400W HPS
200-400W HPS IIMC
IIIMC 2
3
UNLESS OTHERWISE SPECIFIED, SOCKET SETTINGS AT
THE FACTORY ARE ADJUSTED FOR CLEAR LAMPS.
FLAT GLASS
FLAT GLASS
WATTS LENS IES TYPE SOCKET POSITION