Fagor 3CC-239EX - Manual (Page 13)

13
GB
Replacing the Lamp
a. Isolate the hood from the electrical supply.
b. Extract the pull-out drawer completely.
c. Open the light cover support or the rear
grease filter support grate.
d. Always replace burnt-out lamps with 40Watt
max. (E14).
e. Close the light cover support or the rear
grease filter support grate.
f. Before calling for customer service because
the lighting system does not work, make sure
that the lamps are screwed in tightly.
Cleaning
To clean the outside of the hood use a cloth
moistened with denatured alcohol or neutral liquid
detergents. Never use products containing
abrasive.
Wipe brushed stainless steel in the same direction
as the brushing to avoid scratching.
Attention
Failure to observe the rules for cleaning the
appliance and changing and cleaning the filters
may cause fires.
Therefore, we recommend observing these
instructions.
Use:
Two systems are available
Exhaust mode
Vapours are extracted outside through an
exhausting pipe Ø120mm that is affixed to the
connection ring above the hood.
Diameter of the exhausting pipe must be equal to
that of the connection ring.
In the horizontal runs the duct must be slightly
slanted (about 10°) and directed upwards to vent
the air easily from the room to the outside.
Attention!
If the hood is supplied with carbon filter,
then it must be removed.
Filter mode
The air is cleaned by means of carbon filter (two
filters) and then circulated back into the room.
Attention!
If the hood is not supplied with carbon filter,
then it must be ordered and mounted.
This version is used when there is no exhaust
duct for venting outdoors or when it is impossible
to install one.
Installation
When installed, the distance between hood and
burners must be not less than 65 cm. above
electric burners or 75 cm. above gas or mixed-
fuel burners.
Warning!
— The hood cannot be connected to flues of
other appliances that run on energy sources
other than electricity.
— When the hood is used at the same time of
other appliances that run on energy sources
other than electricity, provision must be made
for an adequate supply of air.
— No food must be cooked flambé underneath
the hood.
The use of an unprotected flame is dangerous
for the filters and could cause fires.
Therefore, never use an open flame under the
hood. When frying foods, never leave the pan
alone because the cooking oil could flare up.
— Please, keep to the provisions of official
directives regarding the question of fume
discharge.
— The manufacturers refuse to accept any
responsibility for damage to the hood or its
catching on fire because of failure to observe
the above instructions.
Electrical connection
The electrical tension must correspond to the
tension noted on the label placed inside the
cooker hood. Connect the electrical plug, where
provided, to the an easily accessible outlet in
conformity with local standards in force.
Where an electrical plug is not provided (for direct
connection to electrical network) place a standards
approved bipolar switch with an aperture
distance of not less than 3mm (accessible) from
the contacts.
The manufacturers are not liable for any problems
caused by the user’s failure to observer the
above instructions.