Fagor B-850A - Manual (Page 9)

NOTE: Do not use the blender with food at
temperatures exceeding 100ºC.
Operating the whisk
Push the whisk into the blender coupling
until it locks (Fig. 4). Afterwards, connect
it to the body of the blender (Fig. 5). Place
the blender in the container, connect the
plug to the mains and push the on/off
switch to begin beating. Use the speed
control to select the speed.
You may use the jug (12) or another
container for whisking. The contents of the
bowl can be stored using the corresponding
lid.
NOTE: Do not use the whisk with food at
temperatures exceeding 80ºC.
Operating the chopper
The chopper may be used with dried fruits,
herbs, hard-boiled eggs, dry bread, etc.
Fit the chopper blade (11) on the bowl’s
shaft. Place the ingredients to be chopped
into the chopping bowl.
Fit the chopper lid (9) onto the bowl,
turning it anticlockwise (Fig. 3).
Fit the motor body (2) onto the chopper lid
(9) turning it anticlockwise until it fits firmly
into place (Fig. 3).
Insert the plug into a mains socket and
push the on/off switch. Use the speed
control (6) to select a speed. Once you
have finished chopping, make sure that
you remove the blade from the bowl before
emptying out the contents.
Once you have finished chopping, you can
store the contents of the bowl by using
the multi-purpose bowl lid (14) to seal it
hermetically.
NOTE: Do not use the chopper with food
at temperatures exceeding 80ºC.
Wall mounting
Disconnect the blender and unplug it
from the mains before carrying out any
maintenance or cleaning. Wash all the
accessories immediately after use in order
to prolong their useful life. Take care when
handling the blades, as they are very sharp
and keep them out of the reach of children.
The bowls (10 and 12) and the egg whisk
(8) are dishwasher safe. The remaining
8
• Before connecting the blender, ensure
that the mixer base is correctly fitted to
the appliance.
• Do not use or place any part of the
blender on or near to hot surfaces (gas
or electric hotplates or ovens).
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance by
a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.
4. OPERATION
Preparing for use
This blender is designed to process small
quantities of foodstuff and should not be
used for any other purpose.
Before using for the first time, clean the
casing of the motor with a damp cloth.
Wash the shaft and the blade in hot, soapy
water; do not immerse the upper part of
the shaft. Dry all the pieces thoroughly.
IMPORTANT: Before fitting or removing
any of the parts of this blender, unplug it
from the mains.
Operating the blender
The blender is suitable for processing
light foodstuffs, such as preparing sauces,
soups, mayonnaise or purées.
Fit the accessory that you are going to use
to the motor casing, turning it in an anti-
clockwise direction until it is properly and
securely fitted.
Once the mixer base is fitted (3), plug the
blender into the mains. Place the food to
be processed in a suitable container and
place the blender in the position shown in
Figure 2. Select the speed by turning the
speed control (6). Then push the on/off
switch.