Fagor MG-35 - Manual (Page 8)

7
EN
1. DESCRIPTION GENERAL
1. Body of the appliance
2. Sideburn trimmer
3. Shaver accessory
4. 2 mm comb
5. 4 mm comb
6. Nostril accessory
7. Cleaning brush
8. Base for charging battery
9. Charger stand
Interference suppression: this appliance
has been interference-suppressed
in accordance with the interference-
suppression directives.
Electromagnetic compatibility: this
appliance has been suppressed in
accordance with the EMC (electromagnetic
compatibility) directives.
• This appliance should not be used
by physically, sensorially or mentally
handicapped people or people without
experience or knowledge of it (including
children), unless they are supervised or
instructed in the use of the appliance
by a person responsible for their safety.
• Children should be watched to ensure
they do not play with the appliance.
• For greater protection, we recommend
installing a residual current device
(RCD) with an operational residual
current not exceeding 30 mA. Ask your
installer for advice.
• Do not charge the battery at
temperatures lower than 0ºC or higher
than 40ºC.
• This appliance must not be placed
underwater.
• Before using the hair cutter, you should
become familiar with its different parts
and accessories by studying the figures
carefully.
• Before using it for the first time, check
that the mains voltage coincides with
the voltage indicated on the adapter.
• Do not use the hair cutter on wet
surfaces, near a bath or shower or over
a washbasin with water in it.
• Keep this appliance out of the reach of
children.
• Disconnect the appliance before
carrying out any cleaning or
maintenance operations.
• This appliance is designed for domestic
use only and must be used as
described in this manual.
• Regularly check the state of the cord.
If it is damaged, contact an authorised
technical service.
• If you are using the appliance without
the comb, do no not press it against
your skin as it could cause cuts.
• Do not expose the appliance to direct
sunlight.
2. SAFETY WARNINGS
4. OPERATION
3. CHARGING THE BATTERY
• Check that the appliance is clean,
lubricated and that the battery is
charged.
• Put the ON-OFF switch in the OFF
position.
• Put the shaver into the charger stand to
charge the battery (8).
• Plug in the charger stand (9) to charge
the battery (8). A red light will come on
in the appliance.
• Allow the appliance to charge for around
8 hours. Do not exceed this time.
The appliance has an autonomy
of approximately 45 minutes, but
the battery will achieve optimum
performance when it has been charged
and discharged several times.
• For optimum battery performance, the
following advice should be followed:
- Always fully charge the battery.
- Do not allow the battery to discharge
fully (when the sound of the motor
starts to decrease)
- Allow to cool for a approximately one
hour between using and charging.