Audiovox P-99A User Manual
Page 10
-9-
NOTES ON REMOTE CONTROL USE
1. The remote control operates on a 3-volt lithium battery (type
CR-2025). Install the battery into the compartment at the
bottom of the remote control, making sure to observe correct
polarity as shown in the diagram on the back of the control.
2. If the remote control fails to operate, always check battery
condition and replace if necessary before servicing the unit.
3. Dispose of used batteries properly. Do not heat, disassemble,
or throw used batteries into a fire.
4. Keep the remote control away from areas where it may be
exposed to direct heat, moisture, or sunlight.
8
MANUAL UP/DOWN TUNING – See Main Unit
bo
except
press to increase frequency, press to decrease frequency.
AUTOMATIC SEEK TUNING – See Main Unit
bo
except
press to Seek upward, press to Seek downward.
CD TRACK SELECT – See Main Unit
cl
and
dq
except
press to select a higher track number, press
to select
a lower track number.
CD CUE/REVIEW – See Main Unit
cm
and
dr
except press
for Cue function, press for Review function.
9
RADIO PRE-SET MEMORY 1 – See Main Unit
bq
AUDIO SETTING MEMORY 1 (P1) - See Main Unit
9
DISC DOWN SELECT (D.DN) - See Main Unit
do
bl
RADIO PRE-SET MEMORY 2 – See Main Unit
bq
AUDIO SETTING MEMORY 2 (P2) - See Main Unit
9
DISC UP SELECT (D.UP) - See Main Unit
dp
bm
RADIO PRE-SET MEMORY 3 – See Main Unit
bq
AUDIO SELECT MEMORY 3 (P3) - See Main Unit
9
CD PAUSE - See Main Unit
cn
and
ds
bn
RADIO PRE-SET MEMORY 4 - See Main Unit
bq
TRACK/DISC REPEAT (RPT) – See Main Unit
co
and
dt
bo
RADIO PRE-SET MEMORY 5 – See Main Unit
bq
TRACK/DISC SHUFFLE (SHF) – See Main Unit
cp
and
du
bp
RADIO PRE-SET MEMORY 6 – See Main Unit
bq
TRACK/DISC SCAN (SCN) – See Main Unit
cq
and
el
bq
MODE SELECTOR (MOD) - See Main Unit
bt
and
dn
br
INFRARED SENDER
bs
BATTERY COMPATRMENT