NaceCare Solutions TP8X - Manual (Page 3)

3
Parts provided with the heater
Provided with the heater you find the following parts, necessary to fix the heater on a Santoemma
machine:
• 2 metal brackets, to mount the heater on the machines with model# TP8X, TP12QX, and
TP18SX/DX.
• 1 metal bracket, to mount the heater on the machines with model AV12QX, and AV18AX.
• 2 6mm lock nuts, to mount the metal brackets to the heater.
• 4 screws (M4 x 20mm), used to mount the brackets to the control panel of the machine.
The heater is also provided with a solution hose capable of using water at high temperatures. This
hose can be used to re-circulate hot water into the solution tank, or it can be used to replace the
solution hose of the machine if it is not able to withstand hot water.
Mounting for models TP8X, TP12QX, and TP18SX/DX
1. Unscrew the 4 corner screws in each corner of the control panel cover. Mount the 2 metal
brackets on the control panel of the machine, using the 4 screws M4x20 provided in the kit.
2. Hang the heater on the 2 brackets, by inserting the screws coming out from the rear side of the
heater into the holes of the 2 metal brackets, and tightening them with the 2 6mm lock nuts.
See the picture on the next page for reference.