NaceCare Solutions AV18AX User Manual
Page 6
6
Using with accessories
After filling the tanks with solution and plugging the power cable in to the wall outlet (see steps 1 and
2 of the paragraph SETUP), you need to perform the following operations:
1. Connect the machine to the wand or to the hand-tool using the solution and the vacuum hoses. To
connect the hoses to the machine, remove the vacuum hose, which connects the solution tank to
the vacuum shoe, and the solution hose.
2. Connect the longer vacuum hose to the machine
3. Connect the longer solution hose to the machine
4. Switch on the vacuum motor by setting the switch to the "I" position.
5. Turn the pump to the "II" position. In this position, the solution pump is always on.
6.
To spray water you need to pull the lever situated on the handle of the floor wand or hand tool.
Vacuum
hose
Solution hose