NaceCare Solutions NA20SS - Manual (Page 3)

GROUNDING INSTRUCTIONS BRUSH AND PAD DRIVER
INSTALLATION
This appliance MUST be grounded. If it should
malfunction or break down, the ground reduces the
risk of electric shock. This machine is supplied with
a 3 prong grounded electrical plug and can only be
used with a 3 prong grounded electrical outlet.
NOTE: Improper connection of an equipment
grounding conductor can result in risk of electrical
shock. Check with a qualified electrician or service
person if you are in doubt as to whether the outlet is
properly grounded. Do not modify the plug provided
with the machine. If it will not fit in the outlet, have
a qualified electrician change the outlet to the proper
type. This machine is made for use on a 120 volt
circuit and has a grounded plug as shown in the
illustration below.
To install a brush or pad driver, leave the handle in
the upright position and tip the machine backwards.
The brush and pad driver both attach in the same
manner. Align the 3 cut-outs on the clutch plate with
the 3 cut-outs on the drive hub. Push the brush/pad
driver on to the drive hub and turn it counter
clockwise to lock it in position.
To remove, turn the brush/pad driver clockwise and
pull towards you.
NOTE: ENSURE THAT THE MACHINE IS
UNPLUGGED WHILE PERFORMING THESE
OPERATIONS
PAD CENTERING LOCK
MODEL NA1520/2020 ONLY
HANDLE ADJUSTMENT
To install the pad, tip the machine backwards so it
rests on the rear wheels and handle. After centering
the pad on the pad holder, insert the pad centering
lock and press until you hear it snap in place. To
remove the clamp, press the clip together and pull
the centering lock out. When performing this
operation, make sure that the machine is
unplugged. The handle can be adjusted to any working position
by pushing up on the handle lock. Then position the
handle to the desired position and push the handle
lock down to lock the handle again.