NaceCare Solutions PVR390 - Manual (Page 10)

10
Information for DRY USE Vacuum Cleaners
WARNING:
Read the instruction manual before using the machine.
Operators shall be adequately instructed on the use of thier machine.
As with all electrical equipment, care and attention must be exercised at all times
during use, in addition to ensuring that routine and preventative maintenance is carried
out periodically to ensure safe operation.
Failure to carry out maintenance as necessary, including the replacement of parts to
the correct standard could render this equipment unsafe and the manufacturer can
accept no responsibility in this respect. Maintenance should only be carried out by a
qualified person.
This machine is for DRY USE only and must not be stored outside or used in wet con-
ditions.
The machine shall be disconnected from the mains by removing the plug from the sup-
ply socket during cleaning or maintenance and when replacing parts or converting the
machine to another function.
The machine is not to be used by children or persons with reduced physical, sensory or
mental capabilities, or lack of experience or knowledge, unless they have been given
supervision or instruction.
This appliance is intended to be cleaned and maintained by an adult.
Children being supervised are not to play with the machine.
This machine is not a toy.
CAUTION:
This machine is not suitable for picking up hazardous or explosive dust. Contact your
local distributor if you require a machine capable of performing these tasks.
Ensure that the filtration system fitted to the machine is suitable for the material being
collected.
This vacuum cleaner is intended for indoor use in the collection of dry materials.
This machine should be stored indoors only.
NOTE:
This machine is also suitable for commercial dry use, for example in hotels, schools,
hospitals, factories, shops and offices for other than normal housekeeping purposes.
This product complies with the requirements of IEC60335-2.69.
This vacuum cleaner is fitted with a thermal protection device. If the vacuum cleaner
stops working, remove the plug from the wall before investigating where the fault lies.
If the vacuum cleaner has a blockage, switch off, remove the plug from the wall,
inspect the floor tool, tubes and hose for debris. If the floor tool, tubes and hose are
clear, replace the dust bag and clean the filter.
The vacuum cleaner should be inspected after use for damage.
Not suitable for the collection of biological hazards, hazardous, or explosive dusts .
The vacuum cleaner should be stored in a dry place.
Information for DR
Y
USE V
acuum Cleaners