NaceCare Solutions SM1600 - Manual (Page 11)

Page -11- N.A.C.E. Operator's Manual - SM1200 & SM1600
MAINTENANCE (CONT.)
9. Place the rubber end cap covers over both end
caps (flat side against end cap). Align holes and
secure. Then, slant the brush roll forward so the
end caps are in line with the slots in the cleaner
base. Push the brush roll into the base until
seated. See figure 6.
NOTE: Endcaps are color coded.
10. Place the lower side of the belt into the belt guide
and around the left side of the motor pulley. See
figure 7.
CAUTION: Improper installation of the
brush roll or brush roll belt could cause
carpet or cleaner damage.
11. To install the chrome bottom plate, put the tab on
the base in the slot in the plate. Press the center
of the plate against the base of the machine. Turn
the cam latches to fasten the plate to the base.
See figure 8.
Figure 6
Figure 7
Figure 8
Cam Latch
Tab