Rhin-O-Tuff HD4170 - Manual (Page 13)

12
Trouble Shooting;
Only qualified personnel should attempt to work on this
equipment!
Most of the problems you may encounter are due to setup problems. There is
one fuse on the 115VAC machine and two fuses on the 230VAC machine
located on the rear of the HD-4170 Rhin-O-Roll Coiler that can be replaced by
the customer. Below is a trouble shooting guide to help you through most of the
problems that may be encountered.
Trouble Shooting
Symptom Possible Cause Action
Upper and Lower Rollers
do not rotate. 1) Machine is off. Switch
is in the “O” position.
2) Machine is not
plugged in.
3) Blown fuse. 1) Place switch in the “I”
position.
2) Check both ends of
the power cord.
3) Check fuse. See
Chapter 1 for fuse listing.
Coil tightens on the book. 1) Coil is too small for the
book.
1) Check proper size of
coil. See Chapter 3.
Coil stops before it is
completely through the
book. 1) The holes in the book
are misaligned. 1) This is normal. Try
moving the book around
so the coil rotates in the
holes
Cleaning the HD-4170 Rhin-O-Tuff Coiler;
Caring for your HD-4170 Rhin-O-Roll is important for the proper function of the
machine. The finished tan and gray body should be cleaned with a very light
water dampened cloth. The upper and lower rollers should be cleaned with a
rubber cleaner and rejuvenator dampened cloth while the machine has been
turned off and cooled.
Product Registration;
Product registration is important to establish trouble free warranty repair of any of
your Rhin-O-Tuff equipment. Please fill out and mail in the card provided with
your machine or register on-line at
www.RHIN-O-TUFF.com .