KEMP vCloud Air - Manual (Page 17)

Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 17 / 24
VLM for VMware vCloud Air
Installation Guide
8. By default, the Isolate Public/Private Sites option is enabled. You can choose to
enable/disable this as needed.
When Isolate Public/Private Sites is enabled, GEO separates internal and
external clients and returns only sites from the same type, even if the other
type is the only one available. It sends only routable responses to public IP
requesters and RFC1918 responses to private IP requesters.
When it is disabled, internal clients can be resolved to external hosts if no
other site is available.
9. A Failure Delay (minutes) can be set if needed. If a Failure Delay is set, another option
called Site Recovery Mode becomes available.
10. Enter the IP address of the domain in the IP address text box.
11. If needed, select the Cluster name.
12. Click the Add Address button.
Figure 5-6: Configure FQDN
13. Select the type of health checking to be performed from the Checker drop-down list. For
further information regarding health checking options, refer to the GEO, Product
Overview document.
IP Range Selection Criteria
In the IP Range Selection Criteria menu option you can specify a location or country that applies
to an IP address or range. To do this, follow the steps below:
1. In the main menu of the LoadMaster WUI, select Global Balancing.
2. Select IP Range Selection Criteria.
Figure 5-7: IP Range Selection
3. Click Add IP.