KEMP Hyper-V 2008 R2 - Manual (Page 9)

Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 9 / 18
Virtual LoadMaster for Microsoft Hyper-V
Installation Guide
2. Click Start.
The VLM should begin to boot up.
3. Right-click the VLM and select Connect to open the console window.
Figure 2-4: IP address
4. The VLM should obtain an IP address via DHCP. Make a note of this address.
If the VLM does not obtain an IP address, or if the IP address needs to be changed, it can be
manually configured in the console by following the steps in Section 3.1.
2.5 Licensing and Configuration
The LoadMaster must now be configured to operate within the network configuration.
1. In an internet browser, enter the IP address that was noted previously.
2. Ensure to enter https:// before the IP address.
3. A warning may appear regarding website security certificates. Please click the
continue/ignore option.
4. The LoadMaster End User License Agreement screen appears.
Please read the license agreement and, if willing to accept the conditions therein, click the
Agree button to proceed.
5. A screen will then appear asking if you are OK with the LoadMaster regularly contacting
KEMP to check for updates and other information. Click the relevant button to proceed.