Installing loadmaster on the fujitsu server, Install the loadmaster, Boot the installed loadmaster – KEMP PRIMERGY RX User Manual
Page 6: Loadmaster for fujitsu installation, 2 installing loadmaster on the fujitsu server, 1 install the loadmaster, 2 boot the installed loadmaster
Copyright © 2002 - 2014 KEMP Technologies, Inc. All Rights Reserved. Page 6 / 15
LoadMaster for Fujitsu Installation
Installation Guide
2 Installing LoadMaster on the Fujitsu Server
The following steps must be completed in order to install the LoadMaster software on the
Fujitsu Primergy server.
These instructions were written based on the Fujitsu Primergy RX300 S8.
2.1
Install the LoadMaster
To install the LoadMaster, follow the steps below:
1. Insert the CD into the CD-ROM drive.
2. Boot the server.
Figure 2-1: LoadMaster Installation
3. Once the server boots from the CD, the LoadMaster installation process automatically
begins.
4. Press OK. The installation should complete successfully.
2.2
Boot the Installed LoadMaster
Before rebooting the server, eject the CD.
The server is now ready to be rebooted with the LoadMaster software installed on the local disk.
Within the console, press Ctrl-Alt-Del.
The server should begin to boot from the local disk.