Magikitch'n FC72 - Manual (Page 5)

5
L25‐056 (11/13) R1
A. Uncrate unit and put into place. The hitch pins securing burners must be removed. This
will permit the burners to be readily removed for weekly inspection, cleaning and future
service.
B. FOR INSTALLATION ON LEGS: A set of 4" legs is packed in the top section of the broiler
(unless unit is specifically ordered without). A threaded receptacle is located near each
corner base of the machine. Each leg has a similar mating thread. Raise unit sufficiently to
allow legs to be screwed tightly into receptacles. Level the unit by adjusting bottom feet of
legs. Unit must be level to perform properly. FOR INSTALLATION WITH CASTERS: This
installation shall be made with a connector that complies with the Standard for Connectors
for Movable Gas Appliances, ANSI Z21.69
• CSA-6.16, and with a quick-disconnect
device that complies with the Standard for Quick-Disconnect Devices for Use With Gas
Fuel, ANSI Z21.41
• CSA-6.9.
 Provide an adequate means of restraint without depending on the gas connector, the
quick-disconnect device or its associated piping to limit the appliance movement.
 The restraint (i.e. heavy gauge chain or cable) should be 1000# (4.45 kN) test load and
should be attached to the building structure by some substantial means, such as the
use of anchor bolts into concrete, or lag screws into studs in wooden structures. The
opposite end of the restraint should be affixed solidly to the base of the unit at the back
where it will not become pulled out or cause damage to the appliance.
If disconnection of this restraint becomes necessary at any time, make sure it is
reinstalled after the unit is placed in its original position
and before the unit is placed in
operation.
CAUTION!
Only two of the four casters supplied have brakes. Be sure to install the two casters with
brakes at the
front of the unit. NOTE: Front brakes should be locked before unit is placed
in operation.
C. COUNTER MODELS: All counter equipment is to be sealed to the counter to
comply with applicable sanitation standards. A bead of silicone sealant,
approximately ½" wide, is to be applied to the bottom of the unit approximately ¼" in
from the front, back and side edges.
We suggest a Dow Corning®, GE® or Permatex® silicone ‘RTV’ adhesive sealant or
equivalent. (See NSF Basic Criteria C-2 for details).
D. After installation retain manual for future reference.