Magikitch'n LPG-60 - Manual (Page 8)

L25-003 Rev 4 (09/12)
6
4. INSTALLING the SIDE RACK and TANK on the residential 30” UNIT
(Some steps here will not be necessary if this is a new unit being assembled under Section 2)
A. Remove the charbroiler from the base unit and turn the base unit over to work on it.
B. The mounting rack must be installed on the left side of the 30” unit. Pushing in the snap buttons,
remove the two pipe legs from the left side of the unit.
C. With the 30” tank rack facing in the right direction (see illustration) slide the pipe legs through the
holes in the rack and then re-install them into the sockets in the base. Turn the base unit back upright
onto it’s casters.
D. Loosen the wing studs holding the upper hold down bracket and slide it all the way up. Set the bottom
ring of a 20 lb. vertical propane fuel tank into the two slots in the lower tank bracket and push the tank
collar under the upper hold down bracket. Align the slots in the upper bracket so it will fit over the
collar of the tank. Slide the bracket down over the tank collar and rotate the tank in the rack until the
service valve outlet is aligned for easy installation of the regulator and hose assembly. Press down on
the bracket and tighten the wing screws. Be sure the tank is secure in the rack.
Upper hold down bracket
Tank rack body
Pipe legs
Regulator and hose assembly
Lower tank bracket
20 lb. Tank