Martin Universal Design 92-2100 MURANO Professional Studio Easel - Manual (Page 3)

FIG 10
FIG 11
FIG 12
STEP 10. Center column to Lower
Canvas Tray
Insert Center Column [ID#7] into
oval slot on top edge of Lower Can-
vas Tray [ID#8]. Insert T-nut from
part [ID#C]. See FIG 10.
STEP 11. Center column to Lower
Canvas Tray continued
Insert Carriage bolt [ID#C] into hole
in bottom end of Lower Canvas
Tray [ID#8]. Using phillips screw-
driver [ID# Y] tighten and secure
bolt into T-nut. See FIG 11.
STEP 13. Attaching Center Column
to Side Arm Frame Assembly.
With Side Arm Frame Assembly
laying face up on carpeted surface,
slide Center column’s angled edge
up through Upper side arm connector
[ID#4]. See FIG 13.
STEP 12. Attaching Loop-pull to
Lower Canvas Tray
Attach Loop-pull mechanism [ID#E]
to bottom end of Lower Canvas Tray
using [4] small wood screws [ID#F].
See FIG 12.
FIG 13
FIG 15
STEP 15. Loop-pull Adjustment
To allow Center column to move
freely, you must pull up on loop-pull
mechanism [ID#E]. See FIG 15.
FIG 14
7
8
7
8
7
8
E
7
8
STEP 14. Attaching Center
Column to Side Arm Frame
Assembly, continued...
When attaching Center column to
Side Arm Frame Assembly line up
grooves in Lower Canvas tray to
channels in Side Arms. See FIG 14.
3
3
FIG 16
STEP 16. Upper Canvas Support
Attach Upper Canvas Support, by
sliding it down over the Center
Column. Secure with Knob [ID#G].
NOTE: Loosen Knob to move Upper
Canvas Support to desired position
once Easel is assembled.
See FIG 16.
E
7
6
6
4
5
10
7
G
STEP 17. Side Leg Angle Supports
Attach Side Leg Angle Supports
[ID#9] to Side Arms using the [2]
Knobs [ID#H], washer and bolt.
NOTE: make sure angle support is
attached to inside of Side Arm.
See FIG 17.
FIG 17
STEP 18. Side Leg Angle Supports.
Continued...
See FIG 18 for the correct order of
attachment.
FIG 18
Knob
Washer
Side Arm
Angle Support
6x45mm
Bolt
Pg. 3 Created June 06 RPI
3
9
3
9