Goulds Pumps i-ALERT Condition Monitor - Manual (Page 20)

Troubleshooting
i-ALERT ™ Condition Monitor troubleshooting
Symptom Cause Remedy
There are no green or red flashing LEDs. The battery is dead. Replace the condition monitor.
The unit is deactivated. Activate the condition monitor.
The unit is malfunctioning. Consult your ITT representative
for a warranty replacement.
The red LEDs are flashing, but the temperature and
vibration are at acceptable levels.
The baseline is bad. Check the temperature and
vibration levels and reset the
condition monitor.
The unit is malfunctioning. Consult your ITT representative
for a warranty replacement.
Troubleshooting
18 i-ALERT ™ Condition Monitor Installation, Operation, and Maintenance Manual