Goulds Pumps VRS - IOM - Manual (Page 33)

SPARE AND REPAIR PARTS
REPLACEMENT PARTS PROCEDURE . . . . . . . . . . . . . . . . . . . . . . . . 27
RECOMMENDED SPARE PARTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . 27
REPLACEMENT PARTS PROCEDURE
To ensure against possible long and costly down time
periods, especially on critical services, it is advisable to
have spare parts on hand.
Repair orders will be handled with a minimum of delay if
the following directions are followed:
1. Give model number, size of pump, and serial number.
These can be obtained from the nameplate on the
pump.
2. Write plainly the name and part number of each part
required. These names and numbers should agree with
those on the bill of material.
3. Give the number of parts required.
4. Give complete shipping instructions.
RECOMMENDED SPARE PARTS
Light Duty - Random mildly abrasive particles
(1) Seal/Gasket Set
Medium Duty - Light slurries up to 1.2 SG with
moderately abrasive materials
(1) Impeller
(1) Gland Liner
(1) Suction Liner
(1) Seal/Gasket Set
(1) Set Bearings
Heavy Duty - Slurries over 1.2 SG with highly abrasive
materials
(1) Impeller
(1) Gland Liner
(1) Suction Liner
(1) Shaft/Bearing Assembly
(3) Seal/Gasket Set
Severe Duty - Key process equipment and/or heavy
slurries over 1.2 SG with high heads and highly abrasive
particles
(2) Impeller
(2) Gland Liner
(2) Suction Liner
(3) Seal/Gasket Set
(1) Spare Pump
VRS IOM - 5/08
27
7