Golight 5149 - Manual (Page 2)

The Golight® is a Portable Searchlight designed to be
permanently or temporarily attached to a vehicle for your
specific use. The Searchlight with Directional Flexibility is
controlled by a wired remote, which gives the operator a full
370 horizontal rotation and a 135 vertical tilt with fingertip
control. The Golight® provides superior light penetration with
Cr5 PentaBeam™ technology in a halogen configuration or with
state of the art P-Vex™ lens and LED technology.
The Golight® Includes:
• Golight® Searchlight
• Wired Remote Control
• Permanent Mounting Shoe
(Press spring lock to release and remove light.)
• Permanent Mounting Gasket
• Rockguard (not Available with LED units)
An Optional Magnetic Mounting Shoe is available.
(www.store.golight.com)
MOUNTING INSTRUCTIONS
Temporary (Suction):
1. Always clean mounting surface with a clean cloth.
2. Remove light from permanent mount shoe by depressing
spring-loaded lock and sliding light out.
3. Place suction base on clean, dry surface and move side lever
into the locked position.
WARNING: Check the suction cup frequently to ensure
that suction strength is maintained. Temperature
variations, rough terrain, grease and dirt affect the length
of time that the suction cup will remain in place. Suction
mounting is not recommended for road use.
Permanent:
1. On clean, dry surface, place gasket and shoe in desired
location. Using 3/16” screws, attach shoe to vehicle.
2. Slip the Golight® into the shoe. Verify that the spring lock
secures the Golight® into the shoe. An optional magnetic
mounting shoe is available (see web store).
OPERATION OF GOLIGHT®
1. Place your Golight® into the mounting shoe or attach to the
outside of your vehicle (see mounting instructions).
2. Plug your Golight® into your vehicle’s cigarette lighter outlet
or12 Volt direct battery hookup.
3. Using the remote control, turn on the light by depressing the on/
off button.
4. With the 4-way arrows on the remote control, rotate your light to
the desired location.
5. The spotlight should not be turned on when the snap on lens cover
(rockguard) is attached. (Not applicable for LED)
USAGE:
» This light is intended for off-road and utility use only
» This light is intended to be mounted outside the vehicle while in
use
» This light may only be disassembled and repaired by an
authorized representative
MISUSE:
» This light is not approved for road or highway use
» This light is not approved for underwater use
» This light is not approved for inverted mounting
» This light is not approved for use inside a vehicle or enclosure
and power should be removed prior to placing the light in such
circumstance
» This light may be damaged if operated in icing conditions
» This light may only be dismantled by an authorized Golight
representative
» Any violation of the above referenced misuses will be con-
sidered grounds for warranty refusal
IMPORTANT SAFETY INFORMATION

This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic safety
precautions when using this product to reduce the risk of injury, fire or
electric shock.
 This light is for off road and utility use only. It is not designed for road
use as a driving light.
 FCC RULE Part. 15.21 - Changes or modifications made by the user not
expressly approved by Golight, Inc. for compliance could void the user’s
authority to operate the equipment.
For safe and efficient operation of your Golight®, observe these guidelines:
Using your Golight® in icing conditions could damage the gear motors.
The remote must be kept clean and dry to avoid damage to the internal
circuitry.