Glastender GT-18 - Manual (Page 15)

13
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
T
rouble
S
hooTinG
G
uide
T
rouble or
S
iTuaTion
c
auSe
r
emedy
A. Unit does not run 1. No power (Power light “off.”) 1. Check power source.
2. Defective start switch 2. Replace start switch.
3. Wire connections poor, loose, or broken. 3. Re-crimp and/or replace wire connection.
B. Unit experiences a long delay (up to
two minutes) before beginning a cycle.
1. Incoming water does not reach minimum
operating temperature.
1. See Thermostat Control information on
page 4 and check temperature of water
source.
C. Conveyor runs but holding tank not
filling
1. Water “off.” 1. Turn water “on.”
2. Bad water valve. 2. Test valve, replace if necessary.
D. Conveyor moves intermittently 1. Loose belt. 1. Tighten belt by first loosening the four
motor mount towards front and retighten
bolts. Caution: Excessive belt tension could
cause drive motor failure.
E. Water recirculating, conveyor not mov-
ing
1. Obstruction in tank area 1. Remove obstruction.
2. Conveyor not engaged with conveyor
drive shaft.
2. Rotate conveyor until it engages.
3. Defective drive motor. 3. Replace drive motor.
4. Defective or loose belt. 4. Replace or tighten belt.
F. Water not recirculating 1. Completely plugged pump inlet screen. 1. Clean pump inlet screen.
2. Defective recirculating pump. 2. Replace recirculating pump.
G. Water leaking from recirculating pump
housing - water on floor
1. Defective pump seal. 1. Replace pump seal.
2. Pump housing cracked. 2. Replace housing.
H. Glasses slimy or soapy at end of cycle 1. Sanitizer feed line in detergent container. 1. Clean line and place in proper container.
2. Improper Rinse Aid setting. 2. Adjust chemical setting (see page 3).
I. Recirculating water pressure low 1. Spray box not latched properly. 1. Latch spray box properly.
2. Partially plugged pump inlet screen. 2. Clean pump inlet screen.
Refer to cleaning instructions.
3. Missing or worn spray box gasket. 3. Replace gasket.
J. Detergent, sanitizer, and/or rinse aid
not feeding properly
1. Chemical container is empty. 1. Refill or replace container(s).
2. Feed lines will not fill. 2. Replace defective parts. Notes: The
detergent, sanitizer, or rinse aid product
advances in the line on each stroke of the
pump. The product should hold position
between strokes. If the product falls back
toward the supply container, one or more
of the following conditions may exist:
a. Debris in pump,
b. Split feed line, or
c. Bad pump tube.
Replace parts as necessary.
K. Poor washing results 1. Clogged spray nozzles and dirty holding
tank.
1. Clean unit. See cleaning instructions.
2. Detergent container empty. 2. Fill container.
3. Poor water conditions. 3. Have filter or softener installed.
4. Chemicals not adjusted properly.
5. No hot water. 4. Call chemical technician.
5. Check temperature of water source.