Glastender GT-18 - Manual (Page 5)

3
Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com
u
ncraTinG and
S
TarT
-u
p
i
nSTrucTionS
The glasswasher is shipped in two cartons. After uncrating, follow this procedure:
1. Set in place and install top.
2. Place chemical Feed Lines into the proper chemical containers.
a. Red is detergent.
b. Blue is rinse aid.
c. Clear is sanitizer.
WARNING: The chemicals used in commercial glasswashing are very harsh. Exposure to human skin can
cause severe burns. Chemical containers should be stored in a manner and/or location that pre-
vents them from spilling or splashing. Chemical containers must be secured. Please consult
your chemical vendor to ensure proper storage or call the Glastender factory to purchase a clip-
on chemical rail, part number 01000710.
3. After utility connections described above are completed, plug in glasswasher.
4. Depress Prime switches to fill Feed Lines. NOTE: Always cycle the machine after using the prime switch-
es. Undiluted chemicals will damage stainless steel.
5. Cycle the glasswasher and check chemical settings.
6. If chemical adjustment is required, unplug glasswasher, remove front panel, and adjust chemicals as required
using the Electronic Control Timer. See chemical adjustment procedure below.
7. Replace panel and plug in glasswasher. Cycle the glasswasher and check chemical settings. Repeat step 6
if necessary.
c
hemical
a
djuSTmenT
p
rocedure
The chemical strengths should be tested with a professional test kit by
the chemical supplier. Water samples should be taken during the wash
cycle and the rinse cycle.
Detergent - .30% concentration
Sanitizer - 50 PPM (sodium hypochlorite [bleach])
Rinse Aid - until proper sheeting is achieved
Detergent: If the factory setting does not render the proper concentration,
turn the detergent adjustment knob clockwise to increase or
counterclockwise to decrease the dispense time. Repeat chemi-
cal testing procedure and adjust again if necessary.
Sanitizer: If the factory setting does not render the proper concentration,
turn the sanitizer adjustment knob clockwise to increase or
counterclockwise to decrease the dispense time. Repeat chemi-
cal testing procedure and adjust again if necessary.
Rinse Aid: If the factory setting does not render the proper level of sheet-
ing, turn the rinse aid adjustment knob clockwise to increase
or counterclockwise to decrease the dispense time. Run a test
cycle to check wash results and adjust again if necessary.
Electronic Control Timer
Sanitizer
Detergent
Rinse Aid