Glastender LP108 User Manual

Page 4

Advertising
background image

3

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780

800.748.0423 • 989.752.4275 • Fax 989.752.4444 • www.glastender.com

i

NtroduCtioN

This manual describes the operational features of self-contained BB60, BB84, BB108, ND52, ND72, and ND92 coolers

and two zone coolers. Please review this information before attempting installation and operation.

Long term, trouble-free service will follow if good housekeeping and maintenance procedures are followed. Thank you

for selecting Glastender, Inc. products.

u

tility

r

equiremeNtS

aNd

C

oNNeCtioNS

Electrical: 115 Volt AC, 1 Phase, 60 Hz. A separate 15 Amp circuit is recommended. A 6-foot grounded

cord and plug is included with self-contained models.

Plumbing: Automatic condensate evaporator is included. No drain connection required.

u

NCratiNg

aNd

S

tart

-u

P

i

NStruCtioNS

All models are shipped in one carton. These steps should be followed:

1. If legs or casters are included, bolt them to the base with the bolts provided.

2. Unwrap power cord from base if included.

3. Position unit and level and/or seal as required (see page 4 and 5).

4. All units intended for draft beer must be plumbed to an external drain. On self-contained models with draft beer

and a factory installed finished top, the beer tower drain pan is plumbed through the cabinet and stubs out in the

3" space below the compressor compartment. Connection to an external drain must be made from that point.

5. Place shelves in desired location.

6. Plug into 115 volt AC outlet.

7. Load with bottles or cans and allow time for products to cool.

8. Your Glastender equipment is now ready for use.

o

PeratioN

The operating temperature range is 34°F (1°C) to 40°F (5°C).

Self-contained models include an automatic defrost system. The refrigerator will defrost four times daily for approximately

20 minutes. During the defrost, the fan inside the cooler will remain on and the refrigeration system will turn off.

C

leaNiNg

i

NStruCtioNS

Cleaning is essential to sustaining the integrity of your equipment and preventing corrosion.

ESTIMATED CLEANING TIME: 5 to 10 minutes per unit daily, 45 minutes quarterly

FREQUENCY: Daily cleaning of exterior & door gaskets. Monthly cleaning of condenser filter. Quarterly cleaning of

interior, including shelves.

(Cleaning Instructions continued on page 4)

i

NStallatioN

Advertising
This manual is related to the following products: