Glastender LC84 - Manual (Page 4)

Glastender, Inc. • 5400 North Michigan Road • Saginaw, MI • 48604-9780
800.748.0423 • 989.752.4275 • Fax 800.838.0888 / 989.752.4444 • www.glastender.com
1
1. INSPECTION UPON ARRIVAL
• Immediately upon receipt of the unit, make a visual
inspection of the carton to determine if there is evidence
of damage. Following un-crating, make an inspection for
signs of damage.
• If damage is found, notify the carrier immediately.
• The Transportation Company is liable for damage sustained
during shipment but claims must be made with in 15 days.
2. LOCATION OF REMOTE COOLER
• Unit can be placed up to 150 ft. (45.7m.) from the dispens-
ing station. The low profile design allows the unit to be
located under counter.
• If unit is installed on the floor:
a) the cabinet must be sealed to the floor with an NSF
listed silicon RTV applied around the entire periph-
ery of the cabinet (see fig.1)
b) optional 6” legs must be installed to the cabinet bottom.
• If unit is installed on a countertop or shelf:
a) the cabinet must be sealed to the countertop or shelf
with an NSF listed silicon RTV applied around the
entire periphery of the cabinet. (see fig.1)
b) optional 4” legs must be installed to the cabinet bottom.
• Any location must have the ability to support the operat-
ing weight of the unit. (261 lbs./118 kg.)
• Avoid obstructions to the air intake and exhaust sections
of the unit.
• Minimum clearance between the top, front, and back of unit
and any obstruction is 12 in. (30.5cm.)
• Proper unrestricted airflow is essential.
• After the unit is in place, check to be sure it is level.
3. REMOVING THE FRONT COVER
• Remove the three-(3) screws in front of the unit, and two-
(2) screws on top rear. (see fig.2)
• Lift cover up to disengage from rear of the unit, then
pull forward.
• Do not remove the screws along the sides or back.
i
nsPeCtion and
L
oCation
Fig. 1 Sealing Cabinet with RTV
Fig. 2 Removal of Front Cover
CABINET BOTTOM
RTV TO FORM A FILL ET WHEN
CABINET PLACED UP RIGHT
RTV