Brocks Performance ShortMeg 2 Full System 14" Muffler ZX-14R (12-15) - Manual (Page 3)

Document ID 996434
Page 3 of 9
STEP 4: Remove the Right and Left Fairing Grills:
• Remove fasteners and washers at positions 4, 5, and 6 (Figure 4) for the right side fairing grill.
• Note bolt tab on the fairing grill positioned under the tank cover at fastener 4, pull tank cover
away slightly to release tab. Dotted line shows locations of hidden tab (Figure 4).
• The fairing grill is now held in place by
two rubber snap grommets inserted into
the mid-fairing. Pull the fairing grill away
from the mid-fairing slightly and slide
fairing to the rear to remove. Yellow
circles show locations of hidden snap
grommets (Figure 4).
• Repeat for left fairing grill.
Figure 4 ------------------------->
Caution: When performing the steps below use extreme care when releasing
tank cover from side fairing grommets. The tab shown in (Figure 5 B) has
been known to break easily.
Figure 5 A Figure 5 B
STEP 5: Remove the Tank Cover: The tank cover is held in place by three fasteners (Figure 5
A). Fastener 7 is located on the right side, Fastener 8 on the left side, and Fastener 9 at the front of
the tank cover. Remove Fastener 9. The tank cover is now held in place by pins in snap grommets. Pull
the tank cover evenly in an outward direction on both sides to clear the grommets and hooks. Then lift
the tank cover to remove it from the bike frame.