Brocks Performance ShortMeg 2 Full System 14" Muffler ZX-14R (12-15) - Manual (Page 5)

Document ID 996434
Page 5 of 9
Figure 6 E Figure 7
STEP 7: Remove the Stock Right and Left Muffler Bodies (Figure 7):
• Remove the belly pan by removing the 4 fasteners at location 18.
• Loosen the mid-pipe clamp at location 19.
• Remove the bolt at location 20.
• Remove the passenger rear foot peg bolt at location 21. This bolt will be reused on both sides to
secure the bushing.
• Pull the muffler body to the rear to release it from the collector.
• Left side removal is the same except there is no bolt at location 20.
STEP 8: Remove the Stock Header Assembly (Figure 8): The procedure described
below does not require removal of the radiator. However, the fit is tight, and care should be taken to
avoid damage to the radiator.
• Locate the lower radiator bracket that connects the radiator to the center of the engine block.
Remove the bolt (6 x 22mm) from the bracket supporting the lower portion of the radiator. This will
allow you to gently ease the radiator forward for additional clearance when removing the headers.
• Remove the header nuts. Use of an extension
will allow easier access to the header bolts.
There are two bolts per header tube. Once the
bolts are removed do not allow the header
flange to fall and contact the radiator.
Carefully move the flange to a position away
from the radiator.
• Once all bolts are removed, carefully remove
the header from the engine. Avoid contact
with the radiator.
Figure 8 ------------------------->