Rugged Ridge Rocker Side Panels, Body Armor, 97-06 Jeep Wrangler (TJ) - Manual (Page 2)

Part Number 11650.05 (Rocker Side Panel Kit)
Step 3: Test fit the Side Rocker Guards to the vehicle before removing the
plastic backing film. This will aid in aligning the piece properly before securing
with the two-sided 3M tape.
Step 4: Snap screw clips into the three tabs located under the rocker panels of
the vehicle.
Step 5: Position armor onto lower side rocker panels. Make sure that it is evenly
spaced before applying any pressure to armor. When satisfied with placement
apply pressure to all areas to properly secure armor to vehicle. Secure bottom of
rocker guards with hardware supplied.
Pg.2