Rugged Ridge 4-inch Round Side Steps, Stainless Steel, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

6. Position Driver Side Bar onto brackets. Attach Side Bar to Mounting Brackets using the
included (4) 8-1.25mm x 25mm Hex Head Bolt, (4) 8mm Lock Washers, and (4) 8mmFender
Washers (Figure 4). Do not tighten at this time. NOTE: For 2007 JK’s you will use the rear
mounting holes, and for the 2008 JK’s you will use the front mounting holes (Figure 4).
7. Level and adjust Side Bar and Brackets, then tighten all hardware at this time.
8. Repeat steps 2-7 for Passenger Side Bar.
Front Driver Side Shown
Rear Driver Side Shown
9. Do periodic inspections to the installation to make sure that all hardware is secure and tight.
Page 2 of 2 07/16/08 Rev1 (DP )
Figure 1
Nut Plate
2007 & 2008 JK
(1)10mmx35mm
Hex Head Bolt
(1)10mm Fender
washer, &
(1)10mm Lock
Washer
(1)10mm x 35mm Hex
Head Bolt, (1)10mm
Fender washer, &
(1)10mm Lock
Washer
For 2007 model JK
(1)6mm x 25mm Allen
Bolt,
(1) 6.5mm ID x 18mm
OD x 1.6mm Flat
Washer (outer),
(1) 6.3mm ID x 23mm
OD x 3.2mm Flat
Washer (inner) &
(1) 6mm Nylon Lock
Nut
Figure 2
Figure 3
2007& 2008 up JK Front
(2)6mm x 25mm Allen Bolt,
(2) 6.5mm ID x 18mm OD x 1.6mm
Flat Washer (outer),
(2) 6.3mm ID x 23mm OD x 3.2mm
Flat Washers (inner) & (2) 6mm
Nylon Lock Nuts
8mm x 25mm Hex
Head Bolts, 8mm
Fender washers, &
8mm Lock Washers
Figure 4
For 2008 model JK
uses (2) 6mm bolts
and related hardware.
2008 model uses
forward mounting
holes
2007 model uses
rear mounting
holes
Rear
Front
Rear