Rugged Ridge Rocker Guards, Body Armor, 07-14 Jeep 2-Door Wrangler (JK) - Manual (Page 2)

11651.05 - 4-Door Plastic Rocker Armor JK
11651.06 - 2-Door Plastic Rocker Armor JK
Jeep® JK Wrangler Plastic Rocker Armor Installation Instructions
Page 2
PAGE 2
pic.7
pic.8
Step10: Apply pressure to the rocker armor to insure a strong bond.
Tighten Allen head bolts snug. DO NOT over tighten.
Step9: With Rocker armor in place, peel protective cover from back
side of tape working from the outer edges inward (pic.8).
Make sure that all tape covering is pulled back at the same
time. This will insure that all the protective covering is
removed during the installation. The help of a second
person is recommended for this step.
NOTE: If there are any bulges in the rocker armor start
over with step 6.
Step11: Attach rear clips to lower rocker panel as shown (pic.9).
This clips maintains pressure on the rear of cover to insure
a strong bond.
NOTE: Allow part to sit overnight before driving,
pic.9