Rugged Ridge Tire Carrier, XHD Rear Bumper, 07-14 Jeep Wrangler (JK) - Manual (Page 9)

Page 9 of 9
26. Install the light and bracket assembly into the provided square hole in the tire carrier. There are 4
holes provided for adjustability. Install it in the hole that provides best visibility above the spare tire.
Install the provided M12 Bolt (#7) and Washer (#6) and tighten.
27. Reassemble the connector. Assembly is just the reverse of disassembly. When reinstalling the
terminal ends the paper clip that was used will not be needed. Be sure to push the terminals in until
they snap into place.
28. Connect the wire coming from vehicle with the wire coming from third brake light. Wrap all exposed
wiring with provided wire loom. Secure loose wiring to the tire carrier with provided wire ties.
Finally, test the operation of the third brake light.
Installation is complete. Should tire carrier rattle as it ages, it can be adjusted as indicated in steps 11
and 12. Congratulations on your purchase of another quality Rugged Ridge product.
© Copyright 2008, Omix-Ada
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024