Rugged Ridge XHD Rear Bumper, 76-06 Jeep CJ & Wrangler - Manual (Page 6)

Page 6 of 7
13. Using a supplied M12 x 60 bolt and washer, thread into upper left corner of the bumper and sub-frame
(Figure 18). It will be necessary to lift and/or shift the sub-frame in order to line up all of the holes.
Figure 18.
14. Attach bumper to sub-frames using D-Rings. Place a D-Ring in front of you and look at the mounting
holes. The wider set of holes is the top (Figure 19). Locate the top right corner of the D-Ring and place a supplied
M12 x 60 bolt and washer through the D-Ring and thread into the bumper and sub-frame (Figure 20).
Figure 19. Figure 20.
15. Remove the bolt which was insatlled in step 7. Rotate the D-Ring up and install the remaining 3 M12 x60
bolts and washers (Figure 21). Do not tighten the bolts at this time.
Figure 21.
16. Repeat the procedures from steps 13-15 on the passenger side of the vehicle.