Rugged Ridge HD Off Road Front Bumper With Armor, 97-06 Jeep Wrangler (TJ) User Manual
Page 2
Step #6
The top spacer " if installed can be pushed into place with the slotted side towards the
rear bolt. Have the second person lift up on the required side to help easy the insertion of
the upper spacers. Up to (2) spacers can be installed per side - top, bottom or combination
of both
Step #7:
With the top OE bolts in place install the lower OE bolts. (Insert lower spacers if needed)
With the help of a second person slide the bumper from side to side until it is located in the
center of the vehicle from left to right.
Note: on Rubicon and Sahara models the front flares should meet flush with the
ends of the bumper.
Proper placement of spacers will allow you to rise
or lower the bumper to your desired location and
fitment to front fenders.
Step #8:
Torque all bolts down to 65 foot pounds.
NOTE: Re-torque all bolts after 300 miles.
Step #9:
Wire winch per manufactures recommendations.