Rugged Ridge RRC Rear Bumper, 2-Inch Hitch & Tire Carrier, 87-06 Jeep Wrangler - Manual (Page 3)

(Step 8): Install Post Bar at this time to the top of the tire carrier. Use (1) 3/4" x 3" Hex Head Bolt,
(2) 3/4" Flat Washers, and (1) 3/4" Nylock Nut.
(Step 9): Locate tire mount and install using (3) 3/8"-24 x 1" Hex Head Bolts, (6) 3/8" Flat Washers
and (3) 3/8" Nylock Nuts. Slide mount onto tire carrier and hand tighten. There are two sets
of mounting slots on the tire carrier. With post bar installed test fit the spare tire and
determine what is the best mounting point for your vehicles spare tire. Tighten bolts.
(Step10): Mount rubber bushing to bumper swing arm latching point using supplied phillips head screw.
The rubber bushing is needed to maintain proper preload to secure swing arm latch.
Note: When the spare tire is installed it should set snuggly against the post bar.
For most oversized tires the outer mounting holes will be used.
Tire carrier can be used with tires up to 35".
PRODUCT WARRANTY