Rugged Ridge RRC Mount, XHD Modular Front Bumper, 76-06 Jeep Wrangler - Manual (Page 2)

3. Once all 16 bolts have been started, tighten the front 8 bolts, followed by the 8 top bolts.
Installation is now complete! Note: When used for vehicle recovery, only the D-Ring mounts at the
base of the RRC Hoop are to be used. RRC Hoop is not to be used for towing or vehicle recovery.
NOTE: If aftermarket lights are to be mounted to supplied tabs DO NOT block the function of factory
turn signals or headlights. Lights can be mounted under bars if desired. Spacers will be needed.
Page 2 of 2
Congratulations on the purchase and installation of a quality Rugged Ridge product! Ask your retailer
about the following additional accessories to the JK Modular HD Bumper:
11540.40 - Winch Center Section 11540.42 - Optional Bumper Ends
11540.14 - Optional Hoop - Black
11540.16 - Optional Hoop - Stainless 11540.17 - Optional Stainless D-Rings
11540.13 - Optional Stinger
Please find warranty card supplied with product for more information. Warranty card should be filled out and returned to address listed below.
LIMITED WARRANTY
Applies to Rugged Ridge Products by Omix-Ada Inc.
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024