Rugged Ridge XHD High Mount Snorkel Extension, 07-14 Jeep Wrangler (JK) - Manual (Page 3)

Page 3 of 3 REV.1 06/25/2012
High Intake Installation Instructions: (2007 - UP) Wrangler 2DR & 4DR Unlimited
P/N: 17756.07 - XHD Modular High Mount (Ram intake)
High mount installation:
11
- Position ram intake as
low as possible onto
high intake. Slide 3”
clamp as far down on
ram intake as shown.
Check orientation of
ram and tighten clamp.
12
- Use (2) small M6 caps head
bolts to remount logo to
snorkel body.
10
- Install 3” clamp to ram
intake. Screw head should
be positioned inbound
pointing forward as
shown.
Snorkel system has been designed to reduce possible hydro locking caused by water entering
intake system. The system is designed to provide dry, clean air to the engine and should not be
used to exceed manufactures recommended fording depth. Proper off road driving technics
should be used when fording any type of legal water crossing. It is the owners responsibility to
judge conditions prior to placing vehicle in a situation where water intake is possible. The
system should be used as a safeguard and not a full 100% sealed intake system. Rugged Ridge
/ Omix-Ada Inc. is not responsible for damages caused by improper installation an or use of
snorkel system. System should be cleaned and flushed annually. Drain should be inspected and
water expelled on a regular basis.
Manufactures warranty covers only products supplied by Rugged Ridge / Omix - Ada Inc.
Omix-Ada Inc.
460 Horizon Dr. Suite 400
Suwanee, Georgia 30024