Rugged Ridge Half Doors, Front, 07-14 Jeep Wrangler (JK) - Manual (Page 2)

Page 2 of 4
JK FRONT HALF DOORS
11509.01 JK Front Half Doors
4. Remove (4) temporary bolts from the two hinge locations
of each Half Door. Install supplied Door Hinges with the hinge pins
pointing downward using the supplied M8 Countersunk Bolts.
Tighten to 15 ft-lbs.
6. Install doors by aligning the door hinge to the holes of the
vehicle hinges. Do not force the alignment. It may be necessary to
carefully swing the door back and forth several times to allow the
hinges to properly seat. Install torx nuts removed in step 3. Tighten
to 7 ft-lbs. NOTICE! Do not attempt to close door before making
adjustments detailed in the next step.
3. Remove the torx nut from the bottom of each factory hinge
pin. Set these nuts aside to be re-installed on the Half Doors. To
remove the factory doors, carefully lift the door upward until the
hinge pins completely clear the hinges. It will be helpful to have
someone else assist with this step.
5. Attach the Grab Handle to the door using Grab Handle Mount
Plates and M6 Bolts by carefully aligning with threaded hole locations
on door.