Rugged Ridge Half Doors, Rear, 07-14 Jeep Wrangler (JK) - Manual (Page 3)

Page 3 of 4
JK REAR HALF DOORS
11509.02 JK Rear Half Doors
8. Attach Nylon Door Strap to the door hook located at the lower
front corner of the inner Half Door. Loop the other end around the
factory hook inside the vehicle floor compartment. Replace plastic
cover.
7. Only if necessary adjust the position of the vehicle striker
bar for proper latch engagement. Locate the vehicle striker bar in
the door jamb on the B-pillar. Loosen bolts and adjust as necessary.
Tighten to 19 ft-lbs. NOTICE! Any adjustments made to the vehicle
striker bar will need to be repositioned upon re-installation of factory
doors.
THE FOLLOWING ACCESSORIES ARE DESIGNED FOR USE WITH JK HALF DOORS:
Rugged Ridge Soft Upper Doors Front (part number 13711.15)
Rugged Ridge Soft Upper Doors Rear (part number 13712.15)
Rugged Ridge replacement JK Mirrors (part number 11002.21)
PAINTING INSTRUCTIONS FOR EXTERIOR DOOR SURFACE
Rugged Ridge Half Doors are designed to be painted or used as is. Painting will enhance the look of the doors
while increasing the life of the product. Follow the instructions below for proper painting technique.
1. Remove door hinges before painting. Using painters tape, cover sections of door that should not be
painted including the inner door panel and door latch.
10. Apply Logo to the oval recess located in the lower rear corner of
the door. Be sure the surface of the door is cleaned thoroughly and dry
before Logo is applied. NOTICE! If doors will be painted, do not attach
Logo until the last coat is applied and fully cured.