Rugged Ridge Door Mirror Kit, LED Signal, Dual Focus, Black, 87-02 Jeep Wrangler - Manual (Page 2)

Figure 3. The first hole needs to be drilled in
this location through the hinge and outer
door.
Figure 4. This cut-away of a door shows the
required location of the second hole. It was
necessary to locate the hole nearer the inside
of the door to avoid hitting the lower section
of the window channel. The wire loom shows
the desired wire routing.
Figure 5. The wires and loom can then be
pulled through the door, and the mirror
fastened to the door. Be sure to leave the
wires long enough to provide for full door
movement. Then install the provided male 4-
pin plug and terminals. Wiring these plugs
into the system will make future door removal
quick and easy.
Figure 6. These are the plug assemblies. The
male end is used on the mirror. The female
end is used on the vehicle harness.
Figure 7. Locate and determine the wires
needed. A wiring diagram and/or test light
will be helpful.
Mirror Wiring
The mirror assemblies have two (2)
wires that each contain two (2)
conductors.
BLACK = Ground.
RED = Turn Signal.
Yellow = Parking Light.
These wires need to be integrated into
the vehicle wiring harness. Plugs are
included to allow for easy removal of the
doors. A test light and/or manual will be
helpful. The 1990 YJ wiring required
the parking lights to be wired into the
Blue wire on the headlight switch
harness. LEFT turn to be wired into the