Rugged Ridge Roof Top Storage System, Small - Manual (Page 2)

Part# 12110.02 - 59200 (large) and 12110.01 – 159201 (small)
Page 2 of 3
Auto Back Pack Preparation
NOTE: The surface of the rooftop should be clean and waxed before prior to installing the Auto Back Pack.
1. Identify its bottom and front.
2. The Bottom Portion of the Auto Back Pack, which rests on the vehicle’s roof, is a softer,
lighter material.
3. The zipper, when fully open, opens the Auto Back Pack on three sides.
4. The fourth side is the Front Portion of the Auto Back Pack.
Installation Instructions
NOTE: Determine which type of rooftop the vehicle has and proceed to the specified Section.
•
Proceed to Section 1 if your vehicle is equipped with factory Roof Rails.
•
Proceed to Section2 if your vehicle is equipped without factory Roof Rails.
Section One – Equipped with Roof Rails
1. Place the Auto Back Pack on the vehicle’s roof, with its front facing forward and bottom side down.
2. Wrap the straps of the Auto Back Pack around a roof rail (once around is sufficient).
3. For each pair of straps:
a. Pass the loose strap through the lower connector slot as shown in Figure 1 and
through the other connector slot (Figure 2).
gnf
Figure 1 Figure 2
b. Load the Auto Back Pack.
NOTE: Do not over load the Auto Back Pack. The Standard capacity is 20 cubic feet and
30 cubic feet for the large Auto Back Pack. Refer to you owners manual to determine the
weight capacity of the vehicles rooftop.