Rugged Ridge Hood Vent Insert, Black, 07-14 Wrangler (JK) - Manual (Page 2)

Copyright © 2013 Omix-Ada ® , Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: 770-614-6101 | FAX: 770-614-6069 | [email protected]
07+ JK Hood Vent
9. Remove template.
10. Use a drill and 1” sheet metal hole saw to drill
holes in each location marked with center punch.
7. Further secure template by taping edges down
with painter’s tape in three or four locations.
8. Use an automatic center punch, or a punch and
hammer, in center of four marked locations in each
cutting area. If using a punch and hammer, be
careful not to dent your hood.
4. Use scissors to cut around outside edge of tem-
plate.
5. Use a sharp hobby knife or razor blade to cut out
windshield bumper holes.
6. Place template on hood and align template by
temporarily placing windshield bumpers through
windshield bumper holes.
Do not push windshield
bumpers in enough to snap.
Page 2/4
17759.10
WARNING !
Some hole locations are above support
structure “X-brace.” It is OK for hole saw
pilot bit to drill through X-brace, do not
drill through X-brace completely.