Rugged Ridge Fender Flare Kit, Black, 08-10 Ford F-250, F-350, F-450 SD Pickup - Manual (Page 2)

Optional Painting Instructions
Painting:
1. Apply two even coats of adhesion promoter to flares.
Allow recommended flash time between coats. Let second
coat dry for 15 minutes before primer application.
2. Apply an even coat of primer to flare surface. (A high
build primer is recommended)
3. Paint flares with a automotive grade paint. (A flex
additive must be added to paint)
Page 2 of 2
81630.02
5. Install the plastic tabs centered over the markings in step 4.
Install the u-clamps over the inner lip of the fender centered
over the tab. Install the flare starting with the 10 mm factory
bolt. Next attach the flare using the supplied screws in the
remaining mounting holes. Some pressure may be needed
to install the flare.
U-CLAMP
PHILLIPS
SCREW
PLASTIC
TAB
FLARE
VEHICLE
FENDER
NOTICE: Do not use any harsh chemicals on flares. Use only plastic approved cleaning chemicals.
Pain Preparation:
1. Lightly sand flares with 320 grid sandpaper.
2. Remove all surface contaminants from flares using an
approved grease and wax remover.
3. Wipe flares with a tack rag to remove any dust or dirt.
Rev 6/28/10
Ford Super Duty All Terrain Flare Kit