Rugged Ridge RRC Tubular Steel Flat Fender Kit, 97-06 Jeep Wrangler - Manual (Page 4)

Step(11): Reinstall all accessories and wires as described above. Reverse steps 10-1.
Step(12): Repeat for other side. DO NOT REMOVE BOTH FENDERS AT THE
SAME TIME.
With fenders installed check all bolts for tightness and make any adjustment needed to
properly align body panels. Close hood and check for proper fitment and locking of
safety latch. Remove hook latches from old fenders and install into new holes supplied in
replacement H/D tube fenders.
The optional front turn signal bracket allows you to move the side marker lamps from the
fender fares to the front of the tube fender. The left marker lamp will be used on the right
side and the right marker to the left side. The bracket is designed as a compression fitting
and requires just one bolt to install (Fig. 14 -15). Slide marker light into place and secure
using the original keeper nut used to hold it in place in the fender flare. Some splicing
and wiring will be needed to add side markers if desired. These side marker lamps are not
supplied in this kit. This kit has been designed for Off-Road use only.
Fig.14 Fig. 15
NOTE: great effort has been taken to produce a quality product with few visual defects
in the metal work. Some final body work to fender may be required if painted to match
Jeep®.
(pg.4)