Rugged Ridge Ultimate Locking Console, Black, 76-95 Jeep CJ & Wrangler - Manual (Page 2)

Section One – Installation Instructions continued
3. Adjust the position of the Console front to back and ensure that the shifter
clearance for all gears is not obstructed by the Console position (Figure
3).
4. Using a pen, mark the position of the Mounting Bracket on the bottom of
the Console. (Figure 4).
Figure 3 (13101.xx console shown for Figure 4
reference only. Installation is the
same for 13102.XX)
5. Once the position is marked, remove the Console from the vehicle and set
on a clean working table.
6. Reposition the Mounting Bracket over the marks previously made in Step
4.
7. Secure the Mounting Bracket to the Console using the (2) 8 X ¾” Sheet
Metal Screws provided (Figure 5). Open the console to gain access to the
inside of console.
(Figure 7 - 8).
8. Re-Position the Console between the Driver and Passenger seats.
NOTE: Position the Console as far forward as possible without interfering
with the shifter.
9. Locate the (4) mounting holes on the Mounting Bracket.
10. Using the mounting holes as a drilling guide, drill (4) holes through the
floor of the vehicle using 1/8” drill bit (Figure 6).
CAUTION: Take care not to cut or trip any wires/lines that might
be in the area.
Shifter
Console
Mounting Bracket
Pen