Rugged Ridge Passenger Grab Bar, Billet, 07-10 Jeep Wrangler User Manual
Jk billet aluminum grab bar handle 07-10
Rev. 8/11
Page 1 of 1
SB
11421.10 Brushed
11422.10 Black
JK Billet Aluminum Grab Bar Handle 07-10
Contents: Grab Handle (1)
Spacers (2)
M8 screws (2)
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
Step 1. Remove the factory grab handle. Remove both end covers
by sliding the out away from the grab handle.
Step 2. Remove the hex head screws on both sides of the grab
handle. Remove the handle.
Step 3. Insert the supplied hex bolt thru the handle. Insert a spacer
between the handle and the dash. Start the screw. Do not
tighten. Repeat for opposite side. Once both screws have
been started tighten both screws.
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com
Copyright Omix-Ada 2011