Rugged Ridge Manual Transmission Shifter Bezel, Billet, 07-10 Jeep Wrangler - Manual

Rev. 8/11 Page 1 of 2 SB
Black 11422.12
Brushed 11421.12
JK Billet Aluminum Console Shift Bezel Manual 07-10
Step 1. Remove the shifter knob. Pull it off by firmly pulling it back
and forth until the shifter knob slides off.
Step 2. Remove the existing bezel with a flat tool (e.g. Screwdriver).
Pry up the rear side of the bezel releasing the two attached
clips.
Step 3. With a screwdriver, seperate the lower ring from the boot joint.
Contents: Manual Shifter Bezel (1)
Step 4. Re-assemble parts using your Rugged Ridge
bezel, joint boot and lower ring. Fasten parts together using
the 8mm bolts and nuts provided.
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN