Rugged Ridge HD Tie Rod & Drag Link Kit, 87-95 Jeep Wrangler (YJ) User Manual
Page 4
H/D Cross –Over steering conversion.
P/N: 18050.82 (XJ-TJ-ZJ) 18050.83 (1987-1995 YJ)
WARNING: All KEEPER NUTS SHOULD BE INSPECTED PRIOR TO
DRIVING TO INSURE THAT NONE HAVE LOOSENED DURING
INSTALLATION. Failure to tighten keeper nuts correctly can result in the tie-rod
ends slowly backing out and upsetting your alignment. If not properly maintained
and inspected damage may result. It is the owner’s responsibility to check that all
bolts and or keeper nuts are tight and with in listed torque specs after first 10-20
miles of driving and should be rechecked after 200 miles or after all off-road trips.
(6) (ALL) After complete safety inspection proceed with road test avoiding traffic. Inspect bolts
and tighten if needed. Have a certified 4WD shop or a qualified alignment shop perform the
final alignment and double check all work performed for proper safety.
DISCLAIMER: Rugged Ridge – OMIX-ADA has supplied this part with the understanding that the
purchaser is solely responsible for there vehicle and any modification made beyond original factory
standards. Rugged Ridge – OMIX-ADA is not responsible for any injuries to the owner or damages
to vehicle for improperly installed components, unsafe driving and or misuse of supplied
components.
Page 4