Front installation – Rugged Ridge 4-Inch Lift Kit with Shocks, 07-14 Jeep Wrangler (JK) User Manual
Page 2

Pg 2
Photo #2
Photo #3
Photo #1
Front Installation
:
1. Park the vehicle on flat, level ground and set emergency
brake.
2. Raise the front of the vehicle and support frame rails using jack
stands.
3. Disconnect the front sway bar end links using a 18mm socket.
Disconnect front track bar using a 21mm socket.
(See Photo #1)
4. If installing Rugged Ridge Steering Stabilizer Part# 18475.03,
Remove factory steering stabilizer using 18mm socket. (See
Photo #2)
5. Disconnect front shocks using a 18mm socket. Remove front
tires/wheels and remove front coils. (See Photo #3) Remove
front Shocks.Mark driveshaft & yoke then remove.
6. Locate new Rugged Ridge front bump stop. Place bump stop
on the center of the bump stop pad located on the front axle.
Mark and drill using a 25/64" drill bit. (See Photo #4).
7. Place bump stop in coil spring, and install coil spring. Attach
bump stop to axle using the 3/8 X 4" button head bolts with
one washer under the nut. (See Photo #5)
Photo #4
Photo #5